P1074464_wt.7z

: If a specific area requires no taper, try entering a value of "0" for the draft in that section to maintain verticality while drafting surrounding faces.

: If a face is too complex, use a "Split Line" to break it into smaller segments before applying the draft to each part individually.

: Often used for more complex geometry, this method allows you to use a specific edge or curve as the split point for the draft. This is highly recommended for parts with non-planar divisions. p1074464_wt.7z

: For extremely difficult geometry, copy the surfaces, apply the draft to those surfaces, trim them, and then "Solidify" them back into the main part.

To draft a feature using the file (which likely contains a CAD model for a casting or molded part), you should apply a Draft feature to the relevant faces. This feature creates a taper that allows the part to be extracted from its mold easily. : If a specific area requires no taper,

Based on community discussions regarding similar drafted features, here is how you can effectively apply a draft:

If the standard feature fails (which often happens on complex surfaces like fenders or casting pockets), consider these professional workarounds: This is highly recommended for parts with non-planar

: This is the standard method where you select a "neutral plane" that determines the pull direction. The draft angle is then applied to the faces you select, pivoting them from that plane.